Turbo Print 4010-S Blockout
Printable Flex Film: Polyurethane, 120 µ
POLI-FLEX TURBO PRINT 4010-S BLOCKOUT
POLI-FLEX TURBO PRINT 4010-S BLOCKOUT is a sublimation resistant printable digital flex film with 120 µ for garment lettering. The white matt polyurethane digital flex has a blockout layer to resist dye migration which can happen with some polyester textiles. The POLI-FLEX TURBO PRINT 4010-S BLOCKOUT is suitable for printing using solvent and eco-solvent printing systems and has a non-sticky polyester carrier.
Instructions
Print non-mirrored, let the print dry thoroughly (approx. 24 hours) before further processing. To transfer the print onto the textile we recommend the heat resistant application tape POLI-TACK 853 or 854. If transferring without application tape, cover your print with a siliconised paper whilst pressing.
Prepress garment for 1 second at full temperature before positioning the film. Wash inside out, wait 24 hours after the heat transfer.
Please note that the blockout layer in all blockout flex films can be damaged or destroyed by pressing the film at too high temperature or by numerous pressing.
![]() 130 °C |
![]() 5 sec. |
![]() 2,5 - 3,0 bar |
![]() Warm |
![]() No |
![]() 60 °C |
![]() No |
These instructions are based on the values obtained from practical experience. No responsibility is taken for the correctness of this information. We strongly recommend the evaluation on test material.