Ultimate Print Supersoft 4033
Printable Flex Film: Polyurethane, 50 µ
POLI-FLEX ULTIMATE PRINT SUPERSOFT 4033
POLI-FLEX ULTIMATE PRINT SUPERSOFT 4033 is a printable polyurethane flex film with only 50 µ for garment lettering. The POLI-FLEX 4033 has excellent print and cut properties and a semi matt finish. POLI-FLEX 4033 has an non adhesive PET liner and the film can be used with latex, solvent and eco solvent inks.
Instructions
Print non-mirrored, let the print dry thoroughly (approx. 24 hours) before further processing. To transfer the print onto the textile we recommend the heat resistant application tape POLI-TACK 854. If transferring without application tape, cover your print with a siliconised paper whilst pressing.
Prepress garment for 2 - 3 seconds at full temperature before positioning the film. Wash inside out, wait 24 hours after the heat transfer.
![]() 160 °C |
![]() 15 sec. |
![]() 2,5 - 3,0 bar |
![]() Warm |
![]() No |
![]() 40 °C |
![]() No |
These instructions are based on the values obtained from practical experience. No responsibility is taken for the correctness of this information. We strongly recommend the evaluation on test material.