Siser Brick 1000 gloss
Flex Film: Polyurethane, 1000 µ
Siser Brick Effect Flex Film
The Siser Brick 1000 is a thermal transferrable flex film with 1000 µ thickness, suitable for larger graphics and lettering with an elevated effect.
We recommend cutting only with a high quality precision vinyl cutter and a sharp flock blade.
Siser Brick 1000 is also available in matt.
Instructions
Prepress garment for 2 - 3 seconds at full temperature before positioning the film. Wash inside out, wait 24 hours after the heat transfer.
Gold and Silver only: Transfer as follows, remove carrier cold, cover with teflon sheet or siliconised paper and press again for 5 seconds.
![]() 155 °C |
![]() 20 sec. |
![]() Approx. 3,5 bar |
![]() Cold |
![]() No |
![]() 60 °C |
![]() No |
These instructions are based on the values obtained from practical experience. No responsibility is taken for the correctness of this information. We strongly recommend the evaluation on test material.
Colours shown may deviate from the original colours and are for illustration purposes only!