Siser Brick 600 Flex Film
Flex Film: Polyurethane, 600 µ
Siser Brick 600 Flex Film
The Siser Brick 600 is a 600 µ flex film suitable for textile graphics which need a thicker film than the standard flex films. We recommend cutting with a sharp flock blade. As always with thick films, we do not recommend them for fine details and small lettering.
Certified to the OEKO-TEX® Standard 100 Class II.
Instructions
Prepress garment for 2 - 3 seconds at full temperature before positioning the film. Wash inside out, wait 24 hours after the heat transfer.
![]() 155 °C |
![]() 15 sec. |
![]() Approx. 3,5 bar |
![]() cold |
![]() No |
![]() 60 °C |
![]() No |
These instructions are based on the values obtained from practical experience. No responsibility is taken for the correctness of this information. We strongly recommend the evaluation on test material.
Colours shown may deviate from the original colours and are for illustration purposes only!