Colorprint Extra Nylon
Printable Flex Film: PVC, 150 µ
Siser Colorprint Extra
The Siser Colorprint Extra is a high quality printable heat transfer film with a glossy finish for use on difficult textile substrates such as uncoated nylon and polyamides.
Printable with solvent, eco solvent and resin based thermal transfer printers. (Not for Truevis inks, please consult the manufacturers ink-compatability list). 150 µ thickness, non-sticky polyester carrier.
Instructions
Print non-mirrored, let the print dry thoroughly (approx. 24 hours) before further processing. To transfer the print onto the textile we recommend the heat resistant application tape Siser T.T.D. Advanced. If transferring without application tape, cover your print with a siliconised paper whilst pressing.
Prepress garment for 2 - 3 seconds at full temperature before positioning the film. Wash inside out, wait 24 hours after the heat transfer.
![]() 165 °C |
![]() 15 sec. |
![]() Approx. 3,5 bar |
![]() Warm |
![]() No |
![]() 40 °C |
![]() No |
These instructions are based on the values obtained from practical experience. No responsibility is taken for the correctness of this information. We strongly recommend the evaluation on test material.