Colorprint PU semi-gloss
Printable Flex Film: Polyurethane, 80 µ
Siser Colorprint PU semi-gloss
Siser Colorprint PU semi-gloss/silk gloss is a 80 µ thin printable heat transfer film suitable for solvent and eco-solvent inks. The Siser Colorprint PU is also available with a matt surface. Suitable for cotton, polyester and cotton/polyester mixtures.
Instructions
Print non-mirrored, let the print dry thoroughly (approx. 24 hours) before further processing. To transfer the print onto the textile we recommend the heat resistant application tape Siser T.T.D. Easy. If transferring without application tape, cover your print with a siliconised paper whilst pressing.
Prepress garment for 2 - 3 seconds at full temperature before positioning the film. Wash inside out, wait 24 hours after the heat transfer.
![]() 150 °C |
![]() 15 sec. |
![]() Approx. 3,5 bar |
![]() Warm |
![]() No |
![]() 60 °C |
![]() No |
These instructions are based on the values obtained from practical experience. No responsibility is taken for the correctness of this information. We strongly recommend the evaluation on test material.