Hi-5 Print gloss
Printable Flex Film: Polyurethane, 85 µ
Siser Hi-5 Print gloss
The Siser Hi-5 Print is a printable flex film with a short press time of only 5 seconds at a temperature of only 120 °C (textiles under 150 g/m²) or 150 °C (textiles heavier than 150 g/m²). The 85 µ thick flex film is suitable for printing with Solvent, Eco Solvent oder HP Latex inks. Please check the manufacturer’s printer and ink-compatibility list before printing. Available with glossy or matt surface.
Instructions
Print non-mirrored, let the print dry thoroughly (approx. 24 hours) before further processing. To transfer the print onto the textile we recommend the heat resistant application tape Siser T.T.D. Easy. If transferring without application tape, cover your print with a siliconised paper whilst pressing.
Prepress garment for 2 - 3 seconds at full temperature before positioning the film. Wash inside out, wait 24 hours after the heat transfer.
![]() 120 °C / 150 °C |
![]() 15 sec. |
![]() 3 - 4 bar |
![]() Warm |
![]() No |
![]() 50 °C |
![]() No |
These instructions are based on the values obtained from practical experience. No responsibility is taken for the correctness of this information. We strongly recommend the evaluation on test material.