MDF Key Hanger
Approx. 126 x 254 mm
Subli-Print® MDF Hanger
The Subli-Print® Key Hanger is made of a sturdy approx. 12,7 mm thick MDF board and comes with 4 hooks which are assembled after printing. The Subli-Print® Key Hanger has a printing area of approx. 126 x 254 mm and rear side holes for wall mounting.
Please note that the print area is protected by a film which needs to be removed before printing.
- Key hanger with 4 hooks
- Sturdy 12,7 mm thick quality
- Hidden mounting holes
- Printing area with protective film, approx. 126 x 254 mm
Instructions
How to print on the MDF using TexPrint®R Sublimation Paper:
![]() mirrored |
![]() 190 °C |
![]() 160 sec. |
![]() Approx. 1,5 bar |
![]() Hot |
These instructions are based on the values obtained from practical experience. No responsibility is taken for the correctness of this information. We strongly recommend the evaluation on test material.