POLI-FLEX® TURBO® PRINT 4047 GLOSSY
Solvent Flex gloss
Product information
POLI-FLEX®
TURBO® PRINT 4047 GLOSS
POLI-FLEX®
TURBO® PRINT 4047 GLOSS
is a white opaque printable polyurethane flex film with a glossy surface and a thickness of 100 µ. It is suitable for both light and dark textiles and has very good cutting properties.
POLI-FLEX® TURBO® PRINT 4047 GLOSS has a non-adhesive PET liner which offers significant advantages compared to a paper liner. The film can be printed with latex, solvent and eco-solvent inks.
Instructions
The following information is intended as a guide and may vary due to tolerances (material properties, blade wear, etc.). A test cut is required at each roll change and wash tests are recommended.
Pre-press at full press temperature for 2-3 seconds and wash inside out at least 24 hours after pressing.
| Mirror subject | No |
|---|---|
| Pressing temperature | 130 °C | 150 °C | 160 °C |
| Pressing time | 5 Sekunden | 4 Sekunden | 3 Sekunden |
| Contact pressure | Medium, 2,5 - 3,0 Bar |
| Pull off the backing material | Warm |
| Washable up to | 60 °C, no softener, do not tumble dry |
| Knife / Tool | 45° | Cricut: Premium Fine Point | Cameo: Autoblade | Juliet: 45° |
| Knife pressure | 80 g | Cricut: - | Cameo: 6 | Juliet: 5-10 |
| Preset | Cricut: Heat Transfer (Non-Cricut) | Cameo: Heat Transfer Smooth |
| Notice | To transfer the print onto the textile we recommend the heat resistant application tape POLI-TACK 854. |
Always carry out application tests on the original material.