POLI-FLEX® Luminous Flex Film
Photoluminescent flex film
Product number:
POLI-FLEX 4790
Product information
POLI-FLEX® Luminous Flex Film
POLI-FLEX® Luminous absorbs light and emits it again in the dark.
Due to the high quality of the phosphorescent pigments used and the high pigment content, POLI-FLEX® Luminous has a long-lasting afterglow effect.
Material: PVC, 280 µ.
Instructions
The following information is intended as a guide and may vary due to tolerances (material properties, blade wear, etc.). A test cut is required at each roll change and wash tests are recommended.
Pre-press at full press temperature for 2-3 seconds and wash inside out at least 24 hours after pressing.
| Mirror subject | Yes |
|---|---|
| Pressing temperature | 160 °C |
| Pressing time | 15 seconds |
| Contact pressure | Medium, 3,0 - 3,5 Bar |
| Pull off the backing material | Warm |
| Washable up to | 60 °C, no softener, do not tumble dry |
| Knife / Tool | 45° | Cricut: Premium Fine Point | Cameo: Autoblade | Juliet: 45° |
| Knife pressure | 170 g | Cricut: - | Cameo: 20 | Juliet: 15-20 |
| Preset | Cricut: Card Stock | Cameo: Heat Transfer Smooth |
Always carry out application tests on the original material.