POLI-FLEX® TURBO® Print 4010-S Blockout
Solvent Flex semi-matt
Product information
POLI-FLEX® TURBO® Print 4010-S Blockout
POLI-FLEX® TURBO® Print 4010-S Blockout is a sublimation resistant flex film for use on polyester textiles that tend to resublimate. The 120 micron white semi-matt polyurethane flex film has a blockout layer to prevent discolouration of the printed film after transfer.
POLI-FLEX® TURBO® Print 4010-S Blockout is suitable for solvent and eco-solvent inks, the polyester liner is non-adhesive.
Instructions
The following information is intended as a guide and may vary due to tolerances (material properties, blade wear, etc.). A test cut is required at each roll change and wash tests are recommended.
Pre-press at full press temperature for 2-3 seconds and wash inside out at least 24 hours after pressing.
| Mirror subject | No |
|---|---|
| Pressing temperature | 130 °C |
| Pressing time | 5 seconds |
| Contact pressure | Medium, 2,5 - 3,5 Bar |
| Pull off the backing material | Warm |
| Washable up to | 40 °C, no softener, do not tumble dry |
| Knife / Tool | 45° | Cricut: Premium Fine Point | Cameo: Autoblade | Juliet: 45° |
| Knife pressure | 120 g | Cricut: - | Cameo: 8 | Juliet: 5-10 |
| Preset | Cricut: Heat Transfer (Non-Cricut) | Cameo: Heat Transfer Smooth |
| Notice | To transfer the print onto the textile we recommend the heat resistant application tape POLI-TACK 853 or 854. |
Always carry out application tests on the original material.