Product information


POLI-FLEX® TURBO® Print 4036

POLI-FLEX® TURBO® Print 4036 is a printable, white matt PU flex film with a thickness of 100 µ.

POLI-FLEX® TURBO® Print 4036 is suitable for transfer onto cotton, polyester (non-resublimating) and their blends. It can be printed with eco-solvent, solvent and latex inks.


The following information is intended as a guide and may vary due to tolerances (material properties, blade wear, etc.). A test cut is required at each roll change and wash tests are recommended.

Pre-press at full press temperature for 2-3 seconds and wash inside out at least 24 hours after pressing.

Mirror subject No
Pressing temperature 160 °C
Pressing time 130 °C | 150 °C | 160 °C
Contact pressure 5 seconds | 4 seconds | 3 seconds
Pull off the backing material Warm
Washable up to 40 °C, no softener, do not tumble dry
Knife / Tool 45° | Cricut: Premium Fine Point | Cameo: Autoblade | Juliet: 45°
Knife pressure 80 g | Cricut: - | Cameo: 6 | Juliet: 5-10
Preset Cricut: Heat Transfer (Non-Cricut) | Cameo: Heat Transfer Smooth
Notice To transfer the print onto the textile we recommend the heat resistant application tape POLI-TACK 854.

Always carry out application tests on the original material.