Product information


POLI-FLEX® Ultimate Print Nylon 4035

POLI-FLEX® Ultimate Print Nylon 4035 is a 100 µ white opaque polyurethane flex film for transfers onto nylon fabric. It has a very good cutability and a semi-matt print finish.

POLI-FLEX® Ultimate Print Nylon 4035 has a non-adhesive PET liner and can be printed with latex, solvent and eco-solvent inks.


The following information is intended as a guide and may vary due to tolerances (material properties, blade wear, etc.). A test cut is required at each roll change and wash tests are recommended.

Pre-press at full press temperature for 2-3 seconds and wash inside out at least 24 hours after pressing.

Mirror subject No
Pressing temperature 150 °C
Pressing time 4 seconds
Contact pressure Low, 2,0 Bar
Pull off the backing material Warm
Washable up to 40 °C, no softener, do not tumble dry
Knife / Tool 45° | Cricut: Premium Fine Point | Cameo: Autoblade | Juliet: 45°
Knife pressure 80 g | Cricut: - | Cameo: 6 | Juliet: 5-10
Preset Cricut: Heat Transfer (Non-Cricut) | Cameo: Heat Transfer Smooth
Notice Press for 10 seconds after peeling carrier

Always carry out application tests on the original material.