Siser® Brick 600 Flex Film
Matt flex film 600 µ
Product number:
BRICK 600
Product information
Siser® Brick 600 Flex Film
Siser® Brick 600 is a thick, 600 µ PU flex film for raised and eye-catching designs with a matt finish.
Siser® Brick 600 is not suitable for small lettering and fine details.
Instructions
The following information is intended as a guide and may vary due to tolerances (material properties, blade wear, etc.). A test cut is required at each roll change and wash tests are recommended.
Pre-press at full press temperature for 2-3 seconds and wash inside out at least 24 hours after pressing.
| Mirror subject | Yes |
|---|---|
| Pressing temperature | 155 °C |
| Pressing time | 25 seconds |
| Contact pressure | Medium, 2,5 - 3,5 Bar |
| Pull off the backing material | Cold |
| Washable up to | 40 °C, no softener, do not tumble dry |
| Knife / Tool | 45° | Cricut: Premium Fine Point | Cameo: Autoblade | Juliet: 45° |
| Knife pressure | 170 g | Cricut: - | Cameo: 20 | Juliet: 15-20 |
| Preset | Cricut: Card Stock | Cameo: Heat Transfer Smooth |
Always carry out application tests on the original material.